Network Working Group M. Joras Internet-Draft Meta Platforms, Inc. Intended status: Informational M. Ihlar Expires: 9 January 2025 Ericsson 8 July 2024 A new QUIC version for network property communication draft-joras-sconepro-quic-protocol-00 Abstract This document describes a new QUIC version. The proposed wire format and a set of procedures can be used to communicate network properties between a content endpoint and an on-path device. This is achieved by sending messages in this new QUIC version format adjacent to already established QUIC version 1 or version 2 connections on the same UDP 4-tuple. The network properties are intended to enable self-adaptation of video media rates by content endpoints. Discussion Venues This note is to be removed before publishing as an RFC. Discussion of this document takes place on the Secure Communication of Network Properties Working Group mailing list (sadcdn@ietf.org), which is archived at https://mailarchive.ietf.org/arch/browse/ sadcdn/. Source for this draft and an issue tracker can be found at https://github.com/mjoras/sconepro-quic-protocol. Status of This Memo This Internet-Draft is submitted in full conformance with the provisions of BCP 78 and BCP 79. Internet-Drafts are working documents of the Internet Engineering Task Force (IETF). Note that other groups may also distribute working documents as Internet-Drafts. The list of current Internet- Drafts is at https://datatracker.ietf.org/drafts/current/. Internet-Drafts are draft documents valid for a maximum of six months and may be updated, replaced, or obsoleted by other documents at any time. It is inappropriate to use Internet-Drafts as reference material or to cite them other than as "work in progress." This Internet-Draft will expire on 9 January 2025. Joras & Ihlar Expires 9 January 2025 [Page 1] Internet-Draft QUIC for network property communication July 2024 Copyright Notice Copyright (c) 2024 IETF Trust and the persons identified as the document authors. All rights reserved. This document is subject to BCP 78 and the IETF Trust's Legal Provisions Relating to IETF Documents (https://trustee.ietf.org/ license-info) in effect on the date of publication of this document. Please review these documents carefully, as they describe your rights and restrictions with respect to this document. Code Components extracted from this document must include Revised BSD License text as described in Section 4.e of the Trust Legal Provisions and are provided without warranty as described in the Revised BSD License. Table of Contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Conventions and Definitions . . . . . . . . . . . . . . . . . 3 3. New QUIC Version . . . . . . . . . . . . . . . . . . . . . . 3 4. QUIC Long Header Packet Format . . . . . . . . . . . . . . . 3 5. Packet Protection . . . . . . . . . . . . . . . . . . . . . . 4 5.1. Public Salt . . . . . . . . . . . . . . . . . . . . . . . 5 5.2. HKDF Labels . . . . . . . . . . . . . . . . . . . . . . . 5 6. Frames . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 6.1. Padding Frame . . . . . . . . . . . . . . . . . . . . . . 5 6.2. Data Frame . . . . . . . . . . . . . . . . . . . . . . . 5 6.3. Alternative Hosts Frame . . . . . . . . . . . . . . . . . 6 7. Communication Overview . . . . . . . . . . . . . . . . . . . 6 7.1. Use of Connection IDs . . . . . . . . . . . . . . . . . . 7 8. On Path Verification . . . . . . . . . . . . . . . . . . . . 7 9. Extensibility To Provide Confidentiality and Authenticity . . 7 10. Security Considerations . . . . . . . . . . . . . . . . . . . 8 11. IANA Considerations . . . . . . . . . . . . . . . . . . . . . 8 12. Normative References . . . . . . . . . . . . . . . . . . . . 8 Acknowledgments . . . . . . . . . . . . . . . . . . . . . . . . . 8 Authors' Addresses . . . . . . . . . . . . . . . . . . . . . . . 8 1. Introduction The basic idea of the QUIC version described in this document is to create an independent message flow between a client endpoint and devices in the network, in parallel to an end-to-end QUIC connection [RFC 9000], to exchange network properties. This independent flow uses a separate version of QUIC. This document will not describe what information is exchanged for these properties, but rather the overall way in which the communication functions. Joras & Ihlar Expires 9 January 2025 [Page 2] Internet-Draft QUIC for network property communication July 2024 The new version of QUIC described in this document adheres to the version-independent properties of QUIC specified in RFC 8999. This version of QUIC uses long headers for all its communication. The version of QUIC defined in this document protects packets using publicly known keys, which means that confidentiality and integrity of protocol payload cannot be guaranteed. The document describes how a connection can be upgraded to a QUIC version that supports full TLS protection. 2. Conventions and Definitions The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "NOT RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in BCP 14 [RFC2119] [RFC8174] when, and only when, they appear in all capitals, as shown here. 3. New QUIC Version RFC 8999 defines the version independent properties of QUIC to consist of long and short header packets and version negotiation packets. This document defines a new version of QUIC which exclusively uses Long header packets. This version of QUIC has a single packet type, and a set of frame types used to communicate network properties. Furthermore, packets are protected using publicly-know keys, similar to the way Initial packets are protected in QUIC version 1. 4. QUIC Long Header Packet Format This version of QUIC only uses long header packets with the following format: Long Header Packet { Header Form (1) = 1, Fixed Bit (1) = 0, Forward Bit (1) = 0, Packet Type (2) = 0, Reserved Bits (3), Version (32), Destination Connection ID Length (8), Destination Connection ID (8..160), Source Connection ID Length (8), Source Connection ID (8..160), Payload (..), } Joras & Ihlar Expires 9 January 2025 [Page 3] Internet-Draft QUIC for network property communication July 2024 Header Form: The most significant bit (0x80) of byte 0 (the first byte) is set to 1 for long headers. Fixed Bit: The next bit (0x40) of byte 0 is set to 1. Forward Bit: The next bit (0x20) of byte 0 indicates if a network device that replies to this packet should consume or forward it. By default it SHOULD be set to 0. Packet Type: The next two bits contain a packet type. A single packet type is defined for this protocol with the value 0b00. Future extensions MAY add new packet types. A network device MUST ignore packets with unknown packet types and SHOULD forward such packets. Reserved Bits: These bits are reserved for future use and SHOULD be set to 0. Version: This QUIC version uses the value 0x5509c337, which was chosen at random. Destination Connection ID Length: The byte following the version contains the length in bytes of the Destination Connection ID field that follows it. This length is encoded as an 8-bit unsigned integer. Destination Connection ID: The Destination Connection ID field follows the Destination Connection ID Length field, which indicates the length of this field. A Destination Connection ID MUST be at least 8 bytes long. Source Connection ID Length: The byte following the Destination Connection ID contains the length in bytes of the Source Connection ID field that follows it. This length is encoded as an 8-bit unsigned integer. Source Connection ID: The Source Connection ID field follows the Source Connection ID Length field, which indicates the length of this field. A Source Connection ID MUST be at least 8 bytes long. 5. Packet Protection This version of QUIC uses packet protection as defined for Initial packets in section 5 of [QUIC-TLS]. Joras & Ihlar Expires 9 January 2025 [Page 4] Internet-Draft QUIC for network property communication July 2024 This version of QUIC does not use packet numbers, therefore nonces are created by combining the initial Destination Connection ID with the Source Connection ID of the packet. A sender MUST generate a Source Connection ID with a high probability of being unique for each packet. 5.1. Public Salt A publicly known salt is used to derive the secrets, specifically sconepro_salt=0x6784619005cadc9bb961ec4d31b76892eb1b567e. 5.2. HKDF Labels The labels used in [QUIC-TLS] to derive packet protection keys (Section 5.1), header protection keys (Section 5.4) change from "quic key" to "quicscone key", from "quic iv" to "quicscone iv", from "quic hp" to "quicscone hp", to meet the guidance for new versions in Section 9.6 of that document. 6. Frames The payload of a packet using this QUIC version consists of a sequence of frames. Frames consist of a type field optionally followed by type-specific payload. 6.1. Padding Frame Padding frames are defined in section 19.1 of [RFC9000] and are used to increase the size of a packet. PADDING Frame { Type (i) = 0x00, } 6.2. Data Frame DATA Frame { Type (i) = 0x01, Length (i), Payload (..), } Length: The length of the DATA Frame payload in bytes. Payload: SCONEPRO specific payload such as media bitrate information. Joras & Ihlar Expires 9 January 2025 [Page 5] Internet-Draft QUIC for network property communication July 2024 6.3. Alternative Hosts Frame Used to communicate alternative endpoints. This can be used to send a new request of QUIC version but to the network device's IP address and port instead of using the same 4-tuple than the corresponsing end-to-end QUIC connection. Alternatively, it can also be used to setup a full QUIC version 1 connection from the client to the nextwork device to obtain confidentiality and authentication of the communication. Alternative Hosts Frame { Type (i) = 0x02, Host (..).., } Host: A tuple consisting of a host name, port and a QUIC protocol version. (TODO define format) 7. Communication Overview The goal of this QUIC version is to provide a way to communicate properties between an on-path network device and a QUIC client endpoint, with the QUIC client responsible for the initiation of that communication. Before establishing the communication, a QUIC client usually establishes a QUIC version 1 or 2 end-to-end connection as per RFC 9000. Once this is done, the client opportunistically sends a QUIC long header packet destined to the same endpoint IP address and port using this new version. This packet can be parsed by any capable network element on the path that supports this new QUIC version. If the Forward Bit is set, a capable element MUST forward these packets and send an Alternative Hosts Frame with its own IP address and port number to be used for further communication. This option can be used if more than one capable device might be on the path and needs to see the contents. All capable elements are able to respond to the initial packet in a similar fashion, by creating their own QUIC packets for this QUIC version and sending them to the QUIC client matching the IP/port tuple being utilized by the end-to-end QUIC connection. The QUIC client must be able to distinguish the end-to-end QUIC version 1 or 2 packets and the new QUIC version packets. This can be done by looking for the pattern of packets, combined with trial decryption. Joras & Ihlar Expires 9 January 2025 [Page 6] Internet-Draft QUIC for network property communication July 2024 7.1. Use of Connection IDs SCONEPRO QUIC packets contain both Source and Destination Connection IDs. A client who initiates SCONEPRO communication sets both Source and Destination Connection IDs to randomly generated values. A network device that 'responds' to a SCONEPRO QUIC packet sets the Destination Connection ID to the value of the Source Connection ID of the packet it responds to. The network device sets the Source Connection ID to a randomly generated value. 8. On Path Verification Communication using this new QUIC version MUST only be done with network elements that can be verified to be on the same network path as an end to end QUIC flow. This is because this communication is only meant to be done with network elements that have the ability to, for example, modify and drop packets relevant to an end-to-end QUIC flow. As QUIC packets for this new version are themselves carried in separate UDP datagrams from the end to end QUIC flow, there is not an inherent guarantee that they were generated by a network element. A capable network device MUST set the Destination Connection ID Length and Destination Connection ID fields to the values received in the most recently observed new version QUIC packet sent by a client. 9. Extensibility To Provide Confidentiality and Authenticity The use of keys derived from a publicly known salt does not allow for confidentiality or authenticity of the communication. The only manner of authenticity defined in this document is verification of the on-path nature of a network element. It may be desirable for this version of QUIC to be extended to allow for confidentiality and authenticity. Confidentiality with this protocol could be achieved by further leveraging the provisions of QUIC version 1 to do a TLS handshake between the QUIC client and a capable network element. Authenticity could similarly leverage the provisions of TLS. However, this comes with significant complications. TLS achieves authenticity by using Public Key Infrastructure (PKI), where each participant can choose to trust the certificate offered by their peer. While this PKI exists today for Internet endpoints, there is no such existing PKI for network elements. It is important to note that conducting a TLS handshake would restrict the communication between the QUIC client and exactly one on-path network element. Alternatively, a network element could advertise a set of hosts to which the client can connect using QUIC version 1. Joras & Ihlar Expires 9 January 2025 [Page 7] Internet-Draft QUIC for network property communication July 2024 10. Security Considerations TODO Security 11. IANA Considerations TBD - QUIC version. 12. Normative References [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, DOI 10.17487/RFC2119, March 1997, . [RFC8174] Leiba, B., "Ambiguity of Uppercase vs Lowercase in RFC 2119 Key Words", BCP 14, RFC 8174, DOI 10.17487/RFC8174, May 2017, . Acknowledgments TODO acknowledge. Authors' Addresses Matt Joras Meta Platforms, Inc. Email: matt.joras@gmail.com Marcus Ihlar Ericsson Email: marcus.ihlar@ericsson.com Joras & Ihlar Expires 9 January 2025 [Page 8]